Assembty/Pre-Operation - Craftsman 917.28934 Manual Del Operador

Keys
(2) Keys
Slope Sheet
For Future Use I
Your new tractor has been assembled at the factory with the exception of those parts left
unassembted for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 5/16" wrench Utility knife
(2) 7/16" wrenches Tire pressure gauge
(2) 1/2" wrenches Pliers
(1) 9/16" wrench (1) 3/4" wrench
(1) 3/4" socket with drive ratchet
CHECK BATTERY
1. Lift seat pan to raised position and
open battery box door.
NOTE: If this battery is put into service after
month and year indicated on label (label
located between terminals) charge battery
for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section
of this manual for charging instructions).
When right or left hand is mentioned in this
manual, it means when you are inthe operating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Cut along dashed lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
2. Remove protective materials from trac-
tor hood and grille.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
SeN
Bakery box
Label
ADJUST SEAT
1. Sit in seat.
2. Lift up adjustment lever (A) and slide
seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
3. Release lever to lock seat in position.