Idiomas disponibles
Idiomas disponibles
LED LIGHT FUNCTIONS
See Figure 2, page 8.
When a charged battery pack is installed in the tool, the
LED light will indicate the status of the tool when the tool
is powered on.
TOOL STATUS
Operational
Low Battery (5-25%)
Low Battery (0-5%)
Over Current Protection
Over Temperature Protection
SELECTING A BRUSH ACCESSORY
Selecting the correct type of brush accessory is important in
order to obtain the best performance from the power scrubber.
Select the brush accessory based on the application and
on the surface you wish to clean. Selecting the right brush
accessory will help you clean more efficiently and protect
the surface being cleaned. To reduce the risk of property
damage, always test the brush in an inconspicuous area of
a surface before beginning a project.
NOTE: A brush accessory with medium bristles is included
with your power scrubber. Brush accessories with hard and
soft bristles can be purchased where you bought this product.
BRUSH ACCESSORY SELECTION GUIDE
Soft Bristle (Blue)
Light Duty Cleaning
Medium Bristle (Green)
General Purpose Cleaning
Hard Bristle (Gray)
Heavy Duty Cleaning
STARTING/STOPPING THE POWER
SCRUBBER
See Figure 2, page 8.
To start the motor:
„ Fully depress the on/off button to start the motor.
NOTE: When the motor is on, the brush accessory will
spin continuously.
OPERATION
LED LIGHT SCENARIO
Solid Green
Solid Red
Flashing Red (3 Flashes)
Flashing Red (6 Flashes)
Flashing Red (9 Flashes)
6 — English
„ Press the MAX button for Max Speed.
„ Press the MAX button again to return to normal operating
speed.
To stop the motor:
„ Fully depress the on/off button to stop the motor.
NOTE: When the motor is off, the brush accessory will
stop spinning.
INSTALLING/REMOVING BRUSH
ACCESSORIES
See Figure 3, page 8.
Insert the accessory into the collet and push it in as far as
possible. To remove an accessory, pull it straight out of the
collet.
OPERATING THE POWER SCRUBBER
See Figure 4, page 8.
„ Select the appropriate brush accessory.
„ Hold the scrubber firmly against the surface.
„ Fully depress the on/off button to start the power
scrubber.
„ Move the unit forward and back over the surface to be
cleaned.
NOTE: Move slowly when learning to use the unit and
when scrubbing tough or difficult stains.
NOTE: Do not press down on the unit or keep the unit in
one place over an extended period of time. Doing so could
damage the surface being cleaned.
„ When scrubbing is complete, fully depress the on/off
button to turn the motor off, and wait for the brush ac-
cessory to stop spinning.
„ Remove the brush accessory as described earlier and
clean thoroughly.
NOTICE:
Dirt and debris can damage delicate surfaces. Thoroughly
rinse the brush accessory before use and continue to do
so at regular intervals during use. Thoroughly clean the
brush accessory after use. Allow to dry and always store
brush accessory without bending the bristles.
