Idiomas disponibles
Idiomas disponibles
HAND MOP (10) - fig. 7
• Holding the body (2), push up the lock (7) and remove the mop (10).
• Insert the steam head (1) or adapter (21) into the socket at the bottom of the mop (1) and then the
selected tip - fig. 8.
• See the table below for the purpose of each tip.
• To remove the head (1) or adapter (21), press the lock button (8).
FILLING THE TANK (18) - fig. 6
• Ensure that the appliance is unplugged and the switch (11) is set to the "0" position.
• The tank (18) can be filled while it is fitted to the mop (10) or when it is removed.
• To remove the reservoir (18), press the locking buttons (19).
• Unscrew the valve (20) to the left and pull out.
• Pour the water measured in the cup (17) into the tank - maximum 300 ml.
Tap water can be used to fill the tank, but demineralised water is recommended for hard
water.
• Insert the valve (20) and turn clockwise as far as it will go.
• The water can be poured out after the appliance has been switched off using the button (11),
disconnected from the power supply and cooled down.
• To pour out the water, wait until the unit has cooled down then unscrew the valve, remove the
valve and pour out.
ATTENTION
• Do not unscrew the valve, top up the water or replace the blankets while the appliance is
running.
• Before refilling water or replacing the tip, switch off the appliance with the button (4) and
disconnect from the power supply.
• Do not use the appliance without water - the appliance may overheat.
• Do not pour any cleaning agents, fragrance oils or other chemicals into the tank, as this may
damage the appliance and create a hazard in use.
USE
• Before using the mop, vacuum the surface to be cleaned.
• Make sure the appliance is unplugged and the switch (11) is set to the "0" position.
• Pour water into the tank (18) (see "FILLING THE TANK (18)").
• Fit the appropriate nozzle (see "OPERATION").
• When cleaning carpets, it is recommended to use the pad (16) - fig. 5.
• Do not use the pad (16) for cleaning smooth surfaces as it may be damaged.
• Connect the connection cable to a socket equipped with a protective pin as specified
in the instructions.
• Switch the button (11) to the "I" position - the indicator light in the button (11) will illuminate.
• The lights (13) will illuminate red, indicating preheating.
Preheating will take approximately 20 seconds.
• When the appliance is ready for use, the indicator light (13) will illuminate blue and steam will
automatically be released from the appliance.
• Use the regulator (14) to set the steam intensity suitable for the surface to be cleaned. Turning
the regulator to the left reduces the steam intensity, turning it to the right increases it.
NOTE: Steam intensity control is electronically controlled. It takes up to 3 seconds to adjust the
amount of steam. This is a normal occurrence.
• When the water tank is full, the appliance can run for up to 20 minutes, depending on the selected
steam intensity.
• To disinfect a surface, hold the unit head over the area to be disinfected for approximately
8 seconds. Do not exceed the time of 15 seconds, as this may damage the surface to be cleaned
or cause deposits.
• When finished working, switch off the unit using the button (11) and disconnect from the power
supply.
• Allow the unit to cool down before dismantling and cleaning.
15
