GE AEZ18 Serie Manual Del Propietario Y Instrucciones De Instalación página 7

Idiomas disponibles

Idiomas disponibles

I
Installation
Instructions
Air Conditioner
r-_
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344or visit www.GEAppliances.ca
I
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT- Save these i nstructions
for local inspector's use.
IMPORTANT
--Observe
all governing
codes and ordinances.
• Note to Installer-
Be sure to leave these
instructions
with the Consumer.
• Note to Consumer - Keep these instructions
for
future reference.
• Skill level-
Installation
of this appliance
requires basic mechanical
skills.
• Completion time - Approximately
1 hour
We recommend
that two people install
this product.
Proper installation
is the responsibility
of the installer.
Product failure due to improper
installation
is not
covered under the Warranty.
You MUST use all supplied parts and use proper
installation
procedures
as described in these
instructions
when installing this air conditioner.
(_
ELECTRICAL REQUIREMENTS
Some models require a 115/120-volt AC,
(_
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall outlet
you plan to use is only a 2-prong outlet, it is your
responsibility to have it replaced with a properly
grounded 3-prong wall outlet.
©
Some models require 230/208-volt
AC,
protected with a time-delay fuse or circuit
breaker. These models should be installed on
their own single brunch circuit for best
performance and to prevent overloading
house or apartment
wiring circuits, which
could cause a possible fire hazard from
overheating wires.
CAUTION:
Do not, under any circumstances,
cut or remove
the third (ground) prong from the power
cord.
Do not change
the plug on the power
cord
of this air conditioner.
Aluminum
house wiring
may present
special
problems--consult
a qualified
electrician.
TOOLSYOU WILL NEED
Phillips head screwdriver
Flat-blade screwdriver
Pencil
Ruler or tape measure
Level
Scissors or knife
Power cord includes u current interrupter device. A
test and reset button is provided on the plug case. The
device should be tested on a periodic basis by first
pressing the TEST button and then the RESETbutton
while plugged into the outlet. If the TEST button does
not trip or if the RESETbutton will not stay engaged,
discontinue use of the air conditioner and contact a
qualified service technician.
loading