cecotec READYWARM 21000 CARBON FOCUS Manual De Instrucciones página 35

Fig 5.
Connect the cable to the plug on the heater head.
-
To fix the connection between the two cables, use the lock/protection box.
-
Fig 6.
1. Re-route the cables, including the protection box, through the upper tube.
2. Align the heater head with the upper tube and screw them together with the two M8x10
screws.
3. Hold the heater firmly and hook the cable into the groove at the bottom of the base using
the plate and the two self-tapping screws.
4. Anchor the outdoor heater using the three plugs and screws included in the box.
5. Your standing heater is ready for use.
Warning! Do not connect the heater to the mains if you notice any damage (to the heater, the
cable, or the plug) and do not connect the heater to the mains before installation is complete.
4. OPERATION
Start-up and operation
1. Point the heater head in the correct direction.
2. Plug the power cord into the outlet (220-240 V / 50 Hz).
3. The heater is switched on and off by means of the on/off chain (1). The chain can also be
used to adjust the power.
Chain positions:
1. Off
2. Low power = 900 W
3. Medium power = 1200 W
4. Maximum power = 2100 W
Warning:
This outdoor heater does not have a thermostat, so it continues to emit heat until it is
-
switched off. Keep an eye on the heater when it is on.
Unplug the heater from the wall socket when not in use.
-
Adjusting the heater head
The height of the heater head can be adjusted by loosening the adjustment screws on both
sides of the heater head. When the head is securely in place, be sure to retighten the set
screws in the clearance hole.
READYWARM 21000 CARBON FOCUS
ENGLISH
35