1) To avoid the possibility of burns, keep away from children, the elderly, the sick, pets or
intoxicated people.
2) Do not damage or destroy the power cord. Do not bend, stretch or press the power
cord, as this may cause a fire or electric shock.
3) Make sure the voltage used is between 220-240V, 50Hz (or 60Hz). 12V or 24V is not
compatible.
4) Heaters will consume more current than small appliances, so a separate outlet is
required.
5) Keep away from furniture, curtains or glass. Do not use the heater on or under
carpets.
6) When installed in the bathroom, the heating plate should not be in direct contact with
water (especially not installed near the shower and bathtub) and avoid touching the
device with wet fingers
7) Safety distance: maintain a space of 30 cm from the front or above, 10 cm from the
back, 10 cm from the right or left. The socket should be at least 20 cm from the
ground.
8) Please do not jump or stand on the panel and do not press strongly on it.
9) Do not heat at same part of the body for long time, as this may cause burns..
10) Do not cover the heater with anything, such as towels, quilts or carpets.
11) To avoid electric shock or burns and other accidents, be sure the power plug is not
plugged in or switched on before installation. Unplug the power cord and wait until the
heater is completely cooled if cleaning is needed, use dry fabric to clean the heater,
gasoline or acetate is forbidden.
●
Infrared heating panels require little maintenance or servicing.
●
It is forbidden for laypeople to dismantle or repair the heater as this may cause fire,
electric shock or other accidents.
Problem
It Makes noise when
charged with electricity
The surface of the panel
was slightly raised.
The surface of the heating
panel is slightly warm.
WARNING & PRECAUTION
MAINTENANCE & SERVICING
TROUBLESHOOTING
Reason
Due to the structure of the
heat insulator.
Due to the thermal expansion
of the surface material
1. The voltage is low.
2. In a low-temperature
environment.
[ EN ● 7 ]
Version: 9.0
Measure
It is a normal reaction.
Don't worry about it.
It is a normal reaction.
Don't worry about it.
1. Install a voltage regulator.
2. Use higher voltage.
14.09.2022