Idiomas disponibles
Idiomas disponibles
Problem
Machine not running.
Poor dehumidification
efficiency.
Loud noise when
running.
The drain hose was
properly connected and
Water leakage or the
water still drained to
the tank.
The dehumidifier is
started but doesn't
work.
Reason
Is the power cord connected
properly?
ls the room temperature above
95°F (35°C) or below 41°F (5°C).
ls the room temperature
between 68°F (20°C) and above
95°F (35°C)?
Poor air flow?
Is the ambient humidity too low?
Air intake blocked?
Is the machine placed at an
angle?
Connected to the hose without
pulling out the gray rubber plug
of the water outlet.
The pipe is not connected
properly, the other end of the
pipe is blocked and the water
cannot be discharged properly.
The tank is full or not installed
properly.
The sensor float in the tank got
stuck and didn't reposition
properly.
15
Method
Connect the plug into the
socket.
Drain the water from the tank
and put it back in the correct
position on the body.
Because this product is not
suitable for extreme
environments, the machine will
automatically protect and turn
off, which is a normal
phenomenon.
The machine will cool
automatically, which is normal.
There should be about 7.9
inches(20cm) of space around
the product.
A normal phenomenon.
Clean any dirt from the air inlet
and outlet of the product.
Move the machine to a level
surface.
Pull out the grey rubber plug of
the water outlet before
connecting the water pipe
(please refer to the schematic
diagram of continuous drainage
function page in the manual for
details)
Ensure that both ends of the
water pipe are unimpeded after
connecting the water pipe.
Keeping the water pipe in an
inclined state is more conducive
to gravity drainage.
Empty the tank and reinstall it
in place.
Push the float down to the
lowest position for the correct
float position.
