Idiomas disponibles
Idiomas disponibles
ENGLISH
3. PRODUCT INSTALLATION
Installing the handle and body. Fig. 2
-
Insert the end of the handle into the hole at the top of the appliance's body, perpendicular
to the direction of the appliance, as shown in figure 2. Once you hear a click, make sure the
handle is fixed in place to ensure it was correctly installed.
-
If you wish to remove the handle from the body, press the release hole with a thin object
while pulling the handle from the body.
Installing the battery. Fig. 3
Lift the battery cover and insert the battery into the slot. If installed correctly, the battery will
click into position. The, refit the cover.
Installing the charging base and accessory holders. Fig. 4
After installing the handle and battery, place holder 1 and holder 2 in the direction shown by
the arrow, then press the corresponding clips into the charging base. If installed correctly, the
accessory holders will click into place.
Assembling and disassembling the water tank and the waste-water tank. Fig. 5
-
To remove the water tank or waste-water tank, hold the body of the appliance with one
hand, hold the handle of the tank to be removed with the other hand, and press the water-
tank release tab with your thumb to remove the tank.
-
To re-install it, first place the bottom of the tank to be installed against the edge of the
tank bracket and press the tank into position. You will hear it click into place if correctly
installed.
Filling up the water tank. Fig. 6
1. Remove the water tank as explained in the previous section.
2. Place the tank horizontally, open the cap, and pour clean water up to the marked line.
3. Make sure the tank is tightly closed to avoid leakage.
4. Install the water tank on the appliance's body as explained in the previous section. You will
hear it click into place if done properly.
Fig. 6 key:
1. Filling opening
2. Cap
3. Water tank
Warning
-
This appliance is designed to work with water, but you can also add non-foaming soap.
You can use either distilled water or tap water. Please note that the latter may lead to
limescale deposits, which in turn can clog the appliance.
48
-
The maximum filling capacity of the water tank is 700 ml. Do not exceed the marked line
when filling.
Installing and removing the rotary brush cover and brush. Fig. 7.1-7.2
-
To remove the rotary brush cover, pull the tab and the cover upwards as shown in Figure
7.1. To reattach it, align the clips at both ends of the cover, then press the assembly together
until it clicks into position.
-
To remove the rotary brush, squeeze both holes on the right side of the bottom part and
pull the entire rotary brush assembly outwards to remove it, as shown in Figure 7.2. To
re-install it, follow the reverse procedure.
Please note
To remove the rotary brush, we recommend that you first remove the cover.
4. OPERATION
Fig. 8
1. LED indicator
2. Smart Mode indicator
3. Drying Mode indicator
4. Fault indicator
5. Empty waste-water tank indicator
6. Empty clean-water tank indicator
7. Battery indicator
8. Battery percentage
9. Auto-clean indicator
10. Turbo Mode indicator
Using the electric mop
1. Press the power button to turn the appliance on. The appliance will work on Smart Mode
by default.
2. Press the speed button to switch between the two power levels.
3. Press the spray button to make the electric mop spray water.
4. Press the power button to switch off the appliance.
Note:
-
Pressing the power button or putting the machine in parking position (on the base)
automatically enables Turbo Mode for about 3 seconds before switch-off to facilitate the
absorption of possible liquid in the circuit.
-
Do not vacuum liquid soap with the appliance or add excessively foamy cleaning solutions
to the water tank.
ENGLISH
FREEGO WASH&VACUUM SPRAY
49
