cecotec HIDROBOOST 1600 CAR&BIKE Manual De Instrucciones página 35

ENGLISH
Smoke comes out of the Overheating, overloading or
appliance. motor failure.
There is not enough pressure. The inlet water filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct
size.
The pressure washer does The unit is pressurised.
not turn on. The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
Pressure fluctuates. The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
The motor stops suddenly. The extension cord is too long
or short.
The thermal safety
switch has tripped due to
overheating.
7. TECHNICAL SPECIFICATIONS
Model: HidroBoost 1600 Car&Bike
Product reference: 05402
1600 W, 220-240 V~ 50/60 Hz
Pressure: 9 MPa (90 bar)
H I D R O B O O S T 1600 CAR&BIKE
68
Turn off the device
immediately and contact the
Technical Support Service of
Cecotec.
Clean the inlet water filter.
Check that the connections
and the locking ring are tight.
Contact the Technical Support
Service of Cecotec.
Press the gun trigger.
Check the plug, the mains and
the fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance. Switch off the
device and allow it to cool
down.
Check that hoses and
connections are tight.
Clean it with the cleaning kit.
Contact the Technical Support
Service of Cecotec.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
Max. pressure: 13.5 MPa (135 bar)
Flow: 5.5 l/min (330 l/h).
Maximum flow: 7.1 l/min (426 l/h).
5 ºC - 50 ºC IPX5
Technical specifications may change without prior notification to improve product quality.
Manufactured in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help to protect the environment.
9. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact Cecotec official Technical Support Service at +34 963 210 728.
10. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted or distributed by any means (electronic,
mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC
INNOVACIONES, S.L.
ENGLISH
H I D R O B O O S T 1600 CAR&BIKE
69