cecotec CONGA ROCKSTAR NONSTOP WET Manual De Instrucciones página 26

ENGLISH
4. OPERATION
You can use this vacuum cleaner in two different manners:
- Handheld vacuum cleaner, attaching the accessories directly to the main body.
Upright vacuum cleaner, using the vacuuming tube with the accessories assembled.
-
Using the vacuum cleaner
- Press the power button to turn the vacuum cleaner on or off.
Press the speed dial repeatedly to select the device's operating speed: Eco and Turbo. The
-
device will turn on in Eco mode by default.
Attachments
This device includes different accessories that allow cleaning different types of surfaces,
objects, and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jalisco brush
Install this accessory on the suction base and the latter to the upright vacuum cleaner. This
brush is especially designed for cleaning hard floors, but can be used to efficiently clean soft
floors too.
2 in 1 accessory
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it.
Accessory for corners
This accessory is preferably used with the handheld vacuum cleaner to reach less accessible
dirt in corners.
Articulated vacuuming tube
Use the articulated tube to reach and vacuum dirt from the most inaccessible zones. Press the
button to bend the tube.
Installing the wall bracket Fig. 4
1. Place the bracket on the wall and mark 3 spots to be drilled to fix the bracket. You must
take into account the height of the installation; it is important that vacuuming brush head
rests on the floor to prevent the wall bracket from supporting all the vacuum cleaner's
weight.
2. Drill the 3 holes (previously marked) and insert the pegs and screws.
3. Make sure the bracket is securely fixed to the wall and place the vacuum cleaner on it,
inserting its charging terminals into the bracket's.
50
4. Once the wall bracket is installed, connect the power adapter to the charging port, and
then you can charge the vacuum cleaner by simply sliding it up and down the wall bracket.
Charge and display
- The battery must be charged with the wall bracket while it is connected to the main body.
Connect one of the ends of the power adapter to the power supply and the other to the
charging base.
During charge, the battery indicator will flash. When charging is complete, the battery
-
indicator will remain steady.
- You can also charge the battery without using the wall bracket. You can charge the battery
when the battery is installed or not in the vacuum cleaner. Connect the adapter and connect
the other end to the battery, paying attention to the direction. Once properly connected,
the battery indicator will flash and change to steady when charging is complete.
5. WATERTANK ACCESSORY
- Do not use cleaning agents. Use clean and room temperature water only. Do not use the
vacuum cleaner to vacuum water.
- When the vacuum cleaner is not going to be used for a long period of time, remove the
water tank and empty the remaining water. Do not expose it to direct sunlight or to damp
environments.
Mop installation
- Place the mop cloth on the ground with the Velcro facing upwards.
- Align the mop cloth with the Velcro strips on the water tank and attach it without covering
the wheels.
Replacing the mop
- Remove the water tank from the vacuum cleaner.
- Replace the mop and refill the water tank.
- Install the water tank again, insert the tank in the lower part of the vacuuming brush head,
and press until it is fixed.
Water emission
- When using this product for the first time, make sure the water tank lid is not fully open.
- When the product is not in use, check that the cap is closed, as the product may continue
to let out water if the water tank is full.
ENGLISH
51