Idiomas disponibles
Idiomas disponibles
Tools you will need
Not provided
8mm (5/16")
Thin-blade
screwdriver
socket wrench
Cross-shaped
Monkey wrench
screwdrive
Additional parts (in the plastic bag)
upper hinge-left
hinge cover-left screw hole cover-right
middle hinge-left
stop block-left*2
Allen Wrench(4mm,5/32")
Note: If required, you may lay the
refrigerator on its back in order to gain
access to the base, you should rest it on
soft foam packaging or similar material to
avoid damaging the backboard of the
refrigerator. To reverse the door, the
following steps generally recommended.
1. Stand the refrigerator upright. Open the
door to take out all door bins (to avoid
damage) and then close the door.
Putty knife
8mm (5/16")
wrench
Door stopper-left*2
Caution!
Please slightly squeeze the door bins from
one side toward center, and then move it
upward when taking out the door bins.
Remove screw①, then take down
2.
cover② from the top right side. Be
careful of the electrical connector③
below, because it's still connected. Then
unconnect it and remove cover②.
①
Self-tapping screw
②
Upper hinge cover
①
②
③
3.Press the door switch④ ,then remove it
upward. Install switch④ into cover⑤
(provided in the plastic
other
cover②
into the plastic bag.
④
4.Unscrew screws① by a 8mm(5/16")
socket driver or a spanner, and remove
hinge②. Then put the conector③ into the
hole. Please hold the door by hand when
installing.
①
Special flange screw
②
Upper hinge
③
Electrical connector
5.Remove the fridge door from the
middle hinge by carefully lifting the door
straight up. Then Place the fridge door
on a smooth surface with its upper cover
upwards.
③
Eletrical connector
④
Door switch
③
④
bag). Put the
⑤ Upper hinge
cover-left
①
②
③
9
