KitchenBrothers KB562 Manual De Instrucciones página 23

OPERATING INSTRUCTIONS
Before first use
1. Remove the product from the packaging. Check that the ice scoop and ice
container are included. Remove all tapes from the products.
2. Clean the water and ice container with water and a neutral detergent.
3. Place the product on a flat and stable surface away from direct sunlight and heat
sources.
4. Allow the product to stand still for one hour before use to allow the coolant to
settle.
5. Remove the ice container.
6. Wash the internal accessories with water and mild detergent. Remove the drain
plug and drain the water.
7. Clean the outside of the product with warm water and a mild detergent.
8. Clean the inside and outside with a soft, dry cloth.
Assembly/Installation
1. The product must be properly grounded for your safety. This product's power
cord is equipped with a three-pole plug that fits standard three-pole wall outlets
to minimize the risk of electrical shock.
2. Plug the product into a properly installed, grounded outlet to which no other
appliances are connected.
How to use
1. Insert the plug into the outlet.
2. Open the lid, remove the ice container and pour water into the water reservoir.
Make sure the water does not exceed the 'MAX' line and the water temperature is
between 10˚C and 20˚C. Place the ice container back in the machine.
3. Press the 'ON/OFF' button on the control panel to turn the product on.
4. Press 'SELECT' to set the size of the ice cubes. If the room temperature is below
15°C, it is recommended to select small ice cubes to prevent ice from sticking
together.
5. The ice production cycle takes approximately 6 to 13 minutes, depending on
the size of the ice cubes and the room temperature. The recommended room
temperature is 10°C to 43°C.
6. If there is not enough water in the machine, the machine will automatically turn
off and the 'ADD WATER' indicator will flash. Press the 'ON/OFF' button and refill
water in the water tank up to the 'MAX' line. Press the 'ON/OFF' button again to
turn the product back on. Allow the refrigerant in the compressor to settle for at
least 3 minutes before restarting by pressing the 'ON/OFF' button.
7. When the ice container is full, the 'ICE FULL' indicator light will illuminate. Please
note that the indicator light will not work properly if direct sunlight is shining on it.
If the product does not stop even if ice cubes block the sensor, move the product
to a place where there is no sunlight.
English
23