Removing The Drill Chuck - Sunitec MAB 825 Instrucciones De Manejo

Preparations
Using the drill chuck
Adapter for thread taps
CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: [email protected] • Website: www.csunitec.com
50
Inserting the drill chuck
Push the drill chuck onto the tapered mandrel and push the
‹
combination into the morse taper (3) of the machine. If nec-
essary, use an adapter sleeve.
Open the drill chuck and insert the tool into the drill chuck.
‹
Close the drill chuck by hand and then tighten the drill chuck
‹
with the chuck key.

Removing the drill chuck

Unlock the drill chuck with the chuck key and remove the
‹
tool.
WARNING
Risk of injury!
► Tighten the drill chuck only with the chuck key provided.
► Always remove the chuck key from the drill chuck after tight-
ening or loosening.
Inserting the tool
Insert the thread tap into the adapter for thread taps (G).
‹
Insert the appropriate adapter for thread taps (G) into the
‹
KEYLESS quick-change drill chuck system (A).
Removing the tool
Open the quick-change drill chuck system (A) by pushing up
‹
the sleeve and pull the adapter for thread taps (G) down out
of the chuck system.
Pull the thread tap down out of the adapter for thread
‹
taps (G).
MAB 825/845