Tabla de contenido
Important Safety Instructions
EN
Caution Statements
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
6. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit the apparatus.
7. Only use attachments/accessories specified by the
manufacturer.
8. Unplug this apparatus during lightning storms or when
unused for long periods of time.
9. Refer all servicing to qualified service personnel. Servicing
is required when the apparatus has been damaged in any
way, liquid has been spilled or objects have fallen into the
apparatus, does not operate normally or has been dropped.
Safe operation
Power requirements for this product are 110-230V~ 50/60
Hz.
Should any liquid or object fall into the equipment, please
refer to qualified personnel for service.
Do not take the cover off the equipment without
disconnecting it from the mains.
Safe installation
Ambient temperature should not be higher than 45°C.
Do not place the equipment in a place where it can suffer
vibrations or shocks.
Please allow air circulation around the equipment.
Do not place naked flames, such as lighted candles on or
near the product.
Optical connection instructions
An SC/APC single mode fiber cable must be used. Remove
the protective cover from the optical connector on the unit
and the cap on the cable connector. Carefully align the
guides on both connectors when plugging a cable to the
device, then push the connector all the way in.
Take special care to avoid damaging the unprotected
ends of the connectors, as small scratches, impurities and/
or particles of dirt, oil, grease, sweat, etc. may significantly
affect the quality of the signal.
To clean the ends of the connectors, gently rub with a lint-
free lens cleaning cloth, dampened using additive-free
isopropyl alcohol. Make sure the alcohol evaporates fully
before connecting.
Keep the connector covers and cable caps in a safe place in
case they are needed in the future.
Always fit the covers on the connectors of devices that are
not connected to cables to prevent the laser beam from
damaging the eyes.
Do not turn the transmitter on without a fiber optic cable
connected to it.
Safety measures
- The use of controls or adjustments, as well as different
procedures beyond those specified in this manual could
result in exposure to harmful radiation.
- Do not use the equipment in a way that does not conform
to these operating instructions or under any condition that
exceeds the indicated environmental specifications.
- The laser beam should not be pointed at people and/or
animals.
Symbology
This symbol indicates that the equipment complies
with the safety requirements for class II equipment.
To avoid the risk of electric
shock, do not open the
unit.
The equipment complies with the CE mark
requirements.
The product is EAC certified.
3
Tabla de contenido
