Global 246687 Manual Del Usuario página 2

INSTALLATION
HANDLE AND SUPPORT
FRAME INSTALLATION
PARTS LIST
1. Main Body
2. Handle
3. Stainless Steel Bolt
4. Spacer
5. Wheel
6. Spacer
7. Nut
8. Support Frame
9. 20'L Drain Hose
DRAINAGE INSTALLATION
1. When the tank is at full capacity, the "FULL" light
will power on.
2. An alarm will then sound to notify user. Press the
power button to shut down the system.
3. To drain the water tank, open the front panel to
access tank.
4. Grab tank handle and remove it horizontally.
5. After disposing of the water, replace tank, and
close the front panel.
CONTINUOUS DRAINAGE
In extremely wet conditions, the tank may require
frequent drainage. It can be set for continuous
drainage by completing the following:
1. Open the front cover, remove tank, and dispose
of water.
2. Rotate the drain pipe connector on the water tank.
Use cutting tools to cut the side outlet, and then
install the drain pipe connector to an outlet.
3. Install the included drain hose to the connector
and direct the pipe to the desired area prior to
operating the machine.
4. Clean the water tank, drain the hose and pipe
connector, and shut the front panel.
5. When continuous drainage is not being used,
switch over to water tank usage by using
the sealing washer, without the hole, to stop the
water outflow.
Commercial Grade
Dehumidifier
7 6 5
4
8
Sealing washer with hole
Sealing washer without hole
WARNING:
Do not block the drainage hose. The end of the drainage pipe should not be
higher than the outlet hole. If the drainage pipe end is higher than the outlet
hole, water will not drain properly and may damage unit components.
2
1
3
Pipe connector
Pipe connector
User's Manual
2
3
4 5
6 7
9
Drain
hose