Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan Blades (Continued)
2.
Position the trim cover onto the blade plate
assembly bottom. (Figure 2)
NOTE: Trim cover is included with the blade set,
not with the fan.
1.
IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
3.
To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting
process. (If not used for long periods of time, remove
battery to prevent damage to transmitter). Store the
remote away from excessive heat or humidly.
(Figure 3)
How to Operate Your Ceiling Fan
For illustrative purposes only-not
intended to cover all types of controls
12V 23A
Battery (1 pcs)
13
Blade Plate Assembly
Trim Cover
(not included)
Figure 2
Figure 1
Main Fuse Box
Figure 2
Figure 3
