Idiomas disponibles
Idiomas disponibles
collar to removeany dirtaccumulation.
o Insertnewfilter into cover°
• Putair filtercoverandfilterinto collar
aligningthetab
with the slot.
° Push in on cover and turn clockwise
to
lighten,
MUFFLER
Inspect and replace corroded
muffler as it
could create
a
fire hazard
and/or
damage.
SPARK
PLUG
Change
your spark plug each year to
make your engine start easier and run
better. Set spark plug gap at .030 inch.
Slot
Tab
Air lilter cover
Turn
courter--
clockwise to
remove
CLEANING
IMPORTANT:
For best performance,
keep
mower housing
free of built--up
grass and
trash. Clean underside
of mower housing
after each use.
CAUTION:
Disconnect
spark plug wire
from spark plug and place wire where it
cannot come in contact
with the spark
plug.
• Turn lawn mower
on its side. Make sure
air filter and carburetor
are up. Clean the
underside
of your
fawn mower by
scraping
to remove
build--up
of grass
and trash°
• Clean engine often to keep trash from
accumulating,
A clogged
engine runs
hotter and shortens
engine life.
• Keep finished
surfaces
and wheels free
of all gasoline,
oil, etc.
,, We DO NOT recommend
using a
garden hose to clean lawn mower
unless the electrical
system,
muffler, air
filter and carburetor
are covered
to keep
water out Water in engine can result in
shortened
engine life.
CAUTION:
Before pedorming
any
service or adjustments:
*
Release
control
bar.
°
Make sure the blade and all moving
parts have completely
stopped
,,
Disconnect
spark plug wire from
spark plug and place where it cannot
come in contact
with plug.
LAWN
MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST
CUTTING
HEIGHT"
in
the Operation
section
of this manual.
REAR DEFLECTOR
The rear deflector,
attached
between
the
rear wheels
of your lawn mower, is
provided
to minimize
the possibility
that
objects
will be thrown
ou! the rear of the
lawn mower
into the operator's
mowing
position.
If the rear deflector
becomes
damaged,
it
should
be replaced.
TO ADJUST
HANDLE
Your lawn mower
handle can be raised or
lowered for your mowing
comfort.
Four
(4) positions
are available:
high, medium
high, medium
low and tow
Handles
are
shipped
mounted
in the medium
tow
position.
13
•
To change
from
medium
low to
medium high position, the upperand
lower handle
sections
will have to
be turned over,
•
Remove the cable clips,
•
Remove
the controls
and operator
presence control bar from the upper
handle.
•
Remove the starter rope guide from
the lower handle,
•
Remove
hairpin cotters.
•
Disconnect
the lower handle
from
the handle brackets.
•
Turn
the
handle
over
and reas-
semble the hairpin cotters that have
been removed,
•
Reassemble
the starter rope guide°
•
Reassemble
the controls
and the
operator presence control barto the
upper handle,
