FAQ
EN
Problem Type
Solution
Does leaving the robot on the charging
Leaving the robot on the charging dock ater it's ully charged consumes very little electricity and helps maintain optimal
dock consume power i it's already
battery perormance.
charged?
Conirm that the water tank is illed with water, and clean the mop pad i necessary.
No water comes out o the mopping
Clean the mop i it becomes dirty.
module, or only a little bit comes out
Make sure the mop pad is installed correctly according to the user manual.
Clean the blowhole on the water tank.
Robot doesn't resume cleaning ater
Make sure the robot is not set to Do Not Disturb mode, which will prevent it rom resuming cleaning.
charging
The robot does not resume cleaning when it is manually recharged or placed onto the charging dock.
Moving the robot may cause it to re-position itsel or re-map its surroundings. I the robot is too ar rom the charging
Robot doesn't return to charging dock
dock, it might not be able to automatically return on its own, in which case you need to manually place the robot onto
ater being moved
the charging dock.
18
Specications
Robot
Model
RLS5-WH0
Battery
5200 mAh(Battery Nominal Capacity)
Charging Time
Approx. 6 hours
Wireless Connectivity
Wi-Fi IEEE 802.11b/g/n 2.4 GHz
Rated Voltage
14.4 V
Rated Power
40 W
Operation Frequency
2400-2483.5 MHz
Maximum Output Power
20 dBm
WEEE Inormation
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU which should not be mixed with unsorted
household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point
or the recycling o waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help
prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities or more inormation
about the location as well as terms and conditions o such collection points.
Charging Dock
Model
RCS0
100-240 V ~ 50/60 Hz 0.5 A
Rated Input
Rated Output
19.8 V
1 A
Under normal use o condition, this equipment should be kept a separation dis
tance o at least 20cm between the antenna and the body o the user.
EN
19