Parrot MKi9200 Guía De Instalación Rápida página 15

+12V supply, as you could run down the vehicle's battery.
• On some vehicles, the red and orange power supply wires
may need to be reversed. This can easily be done by rever-
sing the two fuse holders on the Parrot MKi9200 installation
cable.
• Many new vehicles do not have a 12 volt ignition supply.
The 12 V ignition must then be taken elsewhere on the
vehicle such as the fusebox or cigar lighter. An additional
device generating an artificial ignition 12V signal may also
be necessary.
Checking the wiring
In order to check the wiring, connect the screen
before placing it on the dashboard.
• To perform the installation check, turn the ignition on, wait
a few seconds then turn it off once the Parrot MKi9200 is
installed: the message "Good bye!" must be displayed.
• If it is not the case, it is necessary to inverse the positions of
the red and orange wires. Indeed, the red wire of the power
cable must be connected to the permanent 12V, the orange
wire to the 12V ignition and the black wire to the ground.
This can be done simply by reversing both fuse holders
located on the Parrot wiring.
Installing the audio connectors
The music cable grommet system allows you to adjust the
cable length while reducing its wear.
1. Drill a 20 mm hole in your dashboard (glove compart-
ment or parcel tray).
2. Insert manually two flexible arms of the grommet system.
3. Use a flat screwdriver in order to insert the last two arms.
> You can now connect your music cable to the bluebox.
Installing the electronic box
• Avoid installing the electronic box near heating or air-con-
ditioning system, on a spot directly exposed to sunlight or
behind metal walls.
• Make sure the electronic box stays fixed once it is installed
and that it will not move while you are driving.
• Do not reinstall the car stereo forcibly. If you are short of
space behind the car stereo to install the electronic box,
consider installing it in the glove box.
Installing the remote control
• If you want to place the remote control on the steering
wheel, make sure it is securely attached, so it does not
move when you are driving. Do not install the remote con-
trol on the outside of the steering wheel and ensure it does
not get in the way when driving.
► Diagrams p.11.
► Diagrams p.8/9.
15