Idiomas disponibles
Idiomas disponibles
The operation
of any tractor
can
result in foreign
objects
thrown
into the
eyes, which
can result
in severe
eye damage.
Always
wear safety
glasses
or eye shields
while operating
your tractor
or performing
any adjustments
or repairs.
We recommend
standard
safety
glasses
or a wide vision
safety
mask worn
over spectacles.
HOW
TO
USE
YOUR
TRACTOR
TO SET PARKING
BRAKE
Your
tractor
is equipped
with
an operator
presence
sensing
switch.
When
engine
is
running,
any attempt
by the operator
to leave
the seat without
first setting
the parking
brake
will shut off the engine.
1.
Depress
clutch/brake
pedal
(B) all the
way down
and hold.
2.
Pull parking
brake lever (C) up and release
pressure
from clutch/brake
pedal.
Pedal
should
remain
in brake
position.
Make
sure parking
brake will hold tractor secure.
NOTE:
Failure
to move throttle
control
be-
tween
half and full speed
(fast) position,
be-
fore stoppi ng, may cause engine to "backfire".
• Turn
ignition
key (F) to "STOP"
position
and remove key. Always
remove
key when
leaving tractor to prevent unauthorized
use.
• Never
use choke
(N) to stop engine.
IMPORTANT:
Leaving
the ignition
switch
in
any position
other
than
"STOP"
will cause
the battery
to discharge
and go dead.
NOTE:
Under certain conditionswhen
tractor
is standing
idle with the engine
running,
hot
engine
exhaust
gases
may cause
"brown-
ing" of grass.
To eliminate
this possibility,
always
stop
engine
when
stopping
tractor
on grass
areas.
_IbCAUTiON:
Always
stop
tractor
com-
pletely,
as described
above,
before
leaving
the operator's
position.
STOPPING
MOWER BLADES
-
, To stop mower blades, push attachment
chtchswitchintodisengagedposition(r_).
(It_)ATTACHMENT
(t_)ATTACHMENT
CLUTCH
CLUTCH
SWITCH
SWITCH
"ENGAGED ....
DISENGAGED"
GROUND
DRIVE
-
• To stop ground
drive, depress
brake pedal
all the way down.
ENGINE
-
Move throttle
control
(D) between
half and
full speed
(fast)
position.
TO USE THROTTLE
CONTROL
(D)
Always
operate
engine
at full speed
(fast).
Operating
engine
at less than full speed
(fast) reduces engine's
operating
efficiency.
Full speed
(fast)
offers
the
best
mower
performance.
TO USE CHOKE
CONTROL
(N)
Use choke control whenever
you are starting a
cold engine. Do not use to start awarm engine.
To engage
choke
control,
pull knob
out.
Slowly
push knob
in to disengage.
TO MOVE
FORWARD
AND
BACKWARD
The direction
and speed of movement
is con-
trolled bytheforward
and reverse drive pedals.
1.
Start tractor
and release
parking
brake.
2.
Slowly depress
forward
(K) or reverse
(L)
drive pedal to begin movement.
Ground
speed
increases
the further
down
the
pedal
is depressed.
14
