Idiomas disponibles
Idiomas disponibles
• The appliance must not be
folded into sharp creases,
ironed, rolled, twisted,
squeezed or handled in any
way that may damage the
built-in heating wires.
• The appliance may only be
used with the control panel
supplied. The control panel
must not be exposed to water
or any other liquid.
KEY
1. Electric blanket
2. Elastic strap
3. Control panel
4. Connection point
USE
Spread the electric blanket (1) over the
mattress. Secure the electric blanket to
the mattress using the elastic strap (2).
Make sure that it does not reach all the
way to the head where the pillows will
be.
Plug the control panel's connector (5)
into the connection point (4).
UK
The control panel (3) should be outside
the bed at the head end.
Plug in the mains plug and switch the
appliance on using the control panel (3).
The indicator light comes on when the
appliance is on.
There are 4 settings on the control panel:
0:
1/I:
2/II: Medium heat
3/III: High heat
It is recommended that the appliance be
set to 3/III for half an hour before bed
time. Setting 1 is suitable for when you
are in bed.
1
The appliance switches off automatically
2
after having been on for about 3 hours.
3
CLEANING
Heating plaid can be washed at 30 ºC,
4
as all electrical parts are sealed. The
appliance should not be washed too
often, since too many washes cause
wear on the appliance.
• Remove the cord and control unit from
• Allow the appliance to cool down
• Wash the plaid in a washing machine
• Place the plaid on a flat surface and
• IMPORTANT! Allow to dry completely
5
4
16
Off
Low heat
the connector on the appliance before
cleaning.
completely before washing.
at
30 ºC using a mild washing powder.
leave it to dry until completely dry.
after cleaning. Do not use the
appliance if it is damp.
