Idiomas disponibles
Idiomas disponibles
DRY PICK-UP
INSTALLING THE DISPOSABLE FILTER BAG
1. Slide the cardboard collar opening firmly onto
the vacuum port deflector until it stops against
the deflector wall.
2. Position the bag so that it is distributed around
the inside of the tank.
INSTALLING THE CARTRIDGE FILTER
The cartridge filter can be used for wet or dry
pick-up, installation is the same for both.
3. With the power head in an upside down
position, slide the cartridge filter down over
the lid cage, push the filter seals against the
power head.
4. Turn the knob on filter retainer clockwise to
tighten, the filter into place.
5. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
6. Insert the hose end into inlet of tank.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the hose. Twist slightly to tighten the connection.
8. Attach one of the cleaning accessories
(depending on the cleaning requirements) to the
extension wands. Twist slightly to tighten the
connection.
9. Plug the cord into the wall outlet. The cleaner is
ready for use.
10. Turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
REMEMBER!
1. The filter must always be in correct position to
reduce the risk of leaks and possible damage to
vac. Make sure that the filter is completely
covering the filter cage. Make sure there are no
gaps between the filter and the lid. It is very
important to assemble the filter to the cage
without any possible leaks or tears. Any leaks
will allow the picked up debris to be blown out
of the blower port and back into the surrounding
environment.
2. When using the vac to pick up fine dust, it will be
necessary to empty the dust tank and clean or
replace the filter at more frequent intervals to
maintain peak vac performance.
NOTICE: DO NOT USE THE DISPOSABLE FILTER BAG
FOR WET VACUUMING.
WET PICK-UP
UNLOAD THE CARTRIDGE FILTER
1. To remove the filter for cleaning, turn the filter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the filter cap,
then slide the cartridge filter off the lid cage.
then grasp the step of knob tightly with fingers
to pull the cartridge filter out off the cage.
2. To clean the cartridge filter, shake or brush off
excess dirt or rinse with water, dry completely
and re-install.
3. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5
ENGLISH
