IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety advice
For safety purposes we strongly recommend the product to be assembled
by at least 4 people.
Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or performing
any maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
Dispose of all plastic bags safely - keep them away from children's reach.
Keep children away from the assembly area.
When using a stepladder or power tools, make sure that you are following
the manufacturer's safety advice.
Do not climb or stand on the roof.
Do not hang or lay on the profiles.
Heavy articles should not be leaned against the poles.
Keep roof and gutters clear of snow, dirt & leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
If color was scratched during assembly it can be fixed.
Cleaning instructions
In order to clean the product, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
Clean the product once assembly is complete.
Before starting assembly
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled and have a solid base such as concrete,
asphalt, deck etc.
Sort the parts and check against the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they
do not get lost.
Please consult your local authorities if any permits are required prior to constructing
the product.
During Assembly
c;)When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
When encountering these icons, you are requested to either keep the screws
slightly loose or to fully tighten the screws.
L31
4ti
Do not over tighten the screws.
nAttention
During assembly use a soft surface below the parts to avoid scratches
and damages.
Please make sure you install the panels with the UV protected side out
(marked with "THIS SIDE OUT") and remove the sticker as panels are in place.
Step 2C: Connect the profiels (9513) by pushing while closing screws 9487.
Step 3C: Connect the profiels (9324) by pushing while closing screws 9487.
Step 8A: As shown in the illustration, using a pencil/pen mark around the bottom of the leg.
Step 8: Make sure that the frame is perfectly rectilinear by measuring the diagonals and
verifying that they are the same.
Step 11A: Level the profile legs by releasing the screws, adjust the profiles and re -tighten
the screws.
Step 16: Hold the top vent cover until completing assembly.
* Tighten all screws at the end of assembly.
Note:
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
