Craftsman 320.39596 Manual De Instrucciones página 16

THE LIVE=TOOL
iNDiCATOR LIGHT
The belt sander is equipped with a
live=tool indicator light (Fig° 8).
When the tool is plugged into
an electrical supply, the
Bive=tool indicator Bight will
illuminate green to remind you
that the tool is plugged ino
When the tool is unplugged, the
indicator Bight will turn off.
=Fig. 8
Live-tool indicator light
PRESSURE=CONTROL
INDICATOR (Fig. 9)
The pressure=control indicator
Bights let you know if you are
applying the proper amount of
pressure during operation.
if only the green indicator Bight
illuminates, it indicates that you
are applying the correct amount
of pressure.
If the yellow and the green lights
Fig. 9 Pressure-control indicator
both illuminate, they indicate that you are applying a little more pressure
than needed.
If the red, yellow and green indicator lights all illuminate, this indicates that you
are applying too much pressure and you need to lessen the pressure as soon
as possible.
CAUTmON: To prevent possible personal injury or tool or workpiece damage,
always be sure that the pressure control illuminates only green during
tool operation.
SELECTING THE RIGHT SANDING BELT
Different sanding belt grits may be purchased from the store where you
purchased
the tool.
Available grits are: Coarse, Medium and Fine.
Use a coarse grit to sand down rough finishes, medium grit to smooth the work
and fine grit to finish off.
It is best to make a trial run on a scrap piece of material to determine the best
grits for a particular job.
16