Installation - Dometic DTM04 Manual De Instrucciones

Dometic Tank Monitor System
5.3 Dimensions
Ref. Dimension
A 83 mm / 3 .25 in .
B 83 mm / 3 .25 in .
C 51 mm / 2 in . clearance behind wall
D 10 mm / 0 .38 in .
5.4 Approvals
ISO 8846; EMC Directive 2004/108/EC
6

Installation

6.1 Tank Monitor Panel
Caution!
Do not install DTM04 panel in an atmosphere with potentially flammable or
explosive vapors.
1 . Select panel location away from direct contact with water
and oil .
2 . Confirm clearance for wire connections behind wall, hull liner
or bulkhead .
3 . Using control panel template (fig . 8 , page 5), cut out
panel access hole (E, F) and drill fastener holes (G) .
4 . With electrical power off, route 18-gauge stranded copper
wire from power source, through circuit breaker or fuse (not
provided), to panel location . Route additional wire according
to diagram (fig . 4 , page 3 – see wiring diagram key
below), depending on your application, to panel location .
Make sure wires extend out through access hole .
5 . Make proper wiring connections to wires extending from
bottom of circuit panel (fig . 3 A 2, page 3) .
6 . Remove panel cover (fig . 3 A 1, page 3) from circuit panel/
mounting frame (A 2), if necessary, by carefully pulling them
apart .
7 . Install mounting frame to wall with four fasteners (fig . 3 A 3) .
8 . Push panel cover onto mounting frame until it locks into
place .
6.2 "Full Tank" Shut-down Relay (optional accessory)
1 . At step 4 (above), route and connect 14-gauge stranded copper wires according to wiring diagram
(fig . 4 , page 3) and wiring diagram key (see below) . 4
2 . Insert "Full Tank" shut-down relay into receptacle on back of circuit panel .
(fig . 2 , page 2) 2
(fig . 3 A, page 2)
6
4
4 3
3
Ref.
E
F
G
H
3
3
Dimension
111 mm / 4 .375 in .
25 mm / 1 .0 in .
527 mm / 20 .75 in .
69 mm / 2 .75 in .
DTM04 Panel Template
Dimensions
(fig . x , page 5)
Ref. Dimension
A 83 mm / 3 .25 in .
B 83 mm / 3 .25 in .
C 67 mm / 2 .63 in,
D 67 mm / 2 .63 in .
E 55 mm / 2 .16 in .
F 68 mm / 2 .69 in .
G 2 mm / 0 .10 in . dia .
H Cut-out area .
Allow 51 mm / 2 in .
clearance behind wall .
(fig . 1 4, page 2) 1
Specifications
6
9