Idiomas disponibles
Idiomas disponibles
2. If adjustment is necessary, loosen the four
(4) Fence adjustment screws using an Allen
Key. (Adjustment allen key, supplied)
3. Re-position the Fence in its elongated
slots until alignment is achieved.
4. Securely tighten the socket head screws.
WARNING I
When all angular adjustments
have been
successfully
completed, the procudure of
the lower blade guard must be checked to
ensure that it is working
correctly.
The saw must not be used if the lower
blade guard is not operating correctly.
Miter Angle Pointer Adjustment
NOTE: There are dual miter angle scales
cast into the front of the machine base. A
small pointer indicates the angle selected.
Set the rotary table to 0° Miter ensuring that
the 0° Positive Stop is engaged. Check that
the Miter pointer is in exact alignment with
the 0° index mark.
CUTTING HEAD TRAVEL
Cutting Head Downward Travel
Adjustment (Fig. S)
To prevent the blade from contacting any part
of the machines metal base the downward
travel of the Cutting Head can be adjusted.
Lower the Cutting Head and check for any
blade contact with the machine base.
If the downward travel of the Cutting Head
needs to be adjusted:
1. Loosen the Iocknut on the downward
travel stop screw.
2. Turn the adjusting screw out (counter-
clockwise) to decrease the downward travel
of the Cutting Head.
3. Turn the adjusting screw in (clockwise) to
increase the downward travel of the Cutting
Head.
4. Tighten the adjustment screw Iocknut
when satisfactory downward travel of the
Cutting Head is achieved.
If necessary the pointer can be repositioned
by loosening its fastening screw using a #2
Phillips screwdriver, adjusting as necessary
and then tightening the fixing screw securely.
(Fig. S)
25
