Idiomas disponibles
Idiomas disponibles
,_
WARNING:
When servicing,
use only identical
replacement
parts. Use of
any other parts may create a hazard or cause product damage.
To ensure safety
and reliability,
all repairs should
be performed
by a qualified
service technician.
CLEAN THE DUST BAG (Fig. 9)
For more efficient
operation,
empty the dust bag when it is
no more than half full. This will
permit the air to flow through
the
bag better. Always empty and
clean the dust bag thoroughly
when you've finished
sanding
and
before you store the sander.
To empty
the dust bag
1.
2.
3.
Fig. 9
Disconnect the belt sander
from the power source.
Remove the dust bag from the belt sander.
Unzip the dust bag and shake out the dust. (Fig. 9).
Zip up the dust bag and reinstall it on the sander.
Unzip
4.
,_
WARNING:
Collected sanding dust from sanding surface coatings such as
polyurethanes,
linseed oil, etc., can self-ignite in the sander dust bag or elsewhere
and cause fire. To reduce the risk of fire, always empty the dust bag frequently while
sanding and never store or leave a sander without totally emptying its dust bag. Also
follow the recommendations
of the coating manufacturers.
PROBLEM
SOLUTION
The sander does not
work
The sanding
belt is not
centered
on the rollers
during use
CAUSE
Not connected
to power
source
The drive belt is broken
The sanding belt is not
adjusted properly
The sanding belt is
defective
Plug the sander into a
power source
Have the belt replaced
by a qualified service
technician
Adjust the sanding
belt tracking
(see "
ADJUSTING
THE BELT
TRACKING")
Replace with a new
sanding
belt
17
