Use & Maintenance; Fault Condition - branatech PAC17-12-412 Manual Del Usuario

Safety Norms
•
Do not plug or unplug the power plug with wet hands.
•
Do not stop the air conditioning by pulling out the power cord.
•
Do not connect an overvoltage power supply or overload receptacle.
•
Do not use thin rods or hard objects to insert into the body to avoid failure.
•
Do not block the air inlet and outlet in any way.
•
Do not move or store the machine in a dumping state.
•
Do not drink the water discharged from the air conditioner or use it to feed animals and
plants.
•
Do not open the machine housing while the machine is running.
•
Do not use mobile air conditioners in the following environments:Near the heat source,
where flammable gas may leak, places with large dust, places where sunlight is exposed,
and places where it is inclined.
•
Please stop operation and unplug the plug before cleaning.
Use advice
A. Clean the machine
•
Wipe the surface with a soft cloth,wipe the control panel with a dry cloth,do not wash di-
rectly with water.
•
Serious soiling applies a kitchen designated neutral detergent moistened with a soft cloth,
wring dry and wipe.
B. When not used for a long time
•
If the machine is not used for a long time, please pull out the rubber stopper at the drain
and clean the residual moisture inside the machine.
•
Store the power cord, store the machine upright and avoid direct sunlight
Phenomenon
Error code E0 The communication between power board
and display board is bad
Error code E1 The defrost temperature sensor is damaged
Error code E2 The temperature sensor is damaged
Error code E4 The system detects that the machine is full of
water
21
USE & MAINTENANCE

FAULT CONDITION

Reason Solution
1. Check whether the display panel cable
has fallen off and insert the cable
again
2. Replace the main board and the
display panel
Replace the defrost temperature sensor
Replace the temperature sensor
Drain the water