Idiomas disponibles
Idiomas disponibles
USE WITH THE CABLE
• Connect the USB cord terminal (6) to the lower part of the
appliance (Fig.3) and the USB cord next to the adapter (not
included) to the mains (Fig 2-4).
• Remove blade protection (7) and press the ON switch (3) to
start operating.
USE IN SELF MODE, WIRELESS. CHARGING THE BATTERY
• Before using for the first time, it is necessary to charge the
battery.
• Connect the USB cord (6) in the lower part of the unit or in the
charge support stand (5) (Fig. 3-5) and the USB cord next to
the adapter to the mains (Fig. 2-4), the charge indicator (d)
in the control panel (4) will light on. When the load has been
completed, the full load indicator (e) shall be illuminated.
• The first charge of the battery will take 2-3 hours. For later
charges it will be enough to keep it charging during 2 hours.
• To use the appliance remove the adaptor. The battery works
around 60 minutes.
• In order to optimise the durability of the battery bear in mind
the following pieces of advice:
- Never exceed the indicated loading times for the battery.
- It is important to discharge the battery before it is
recharged, leave it on until it stops or the power decreases
clearly.
- The battery must be recharged every 6 months if it has not
been used for said period of time.
- Also recharge if it has not been used for more than a month.
OPERATION
• The blade block (2) is placed in the appliance by fitting the tab
into the groove and exerting a slight pressure (Fig. 6).
• For an accurate shave, the hair should be short.
• Remove blade protection (7).
• Turn it on by pressing the ON switch (3) and slide it making
small circular movements along the face, exerting a gentle but
constant pressure (Fig. 7).
• The heads move in different directions to facilitate shaving in
the most difficult places.
• To remove blade block (2), carefully pull it for cleaning (Fig.9).
The blades can be removed individually from the block by
pulling them upwards and then, clean under the tap or with the
brush (7).
• When finished, place the blade protection (7) (Fig.8).
MAINTENANCE AND CLEANING
• Before doing anything, make sure the hair clipper is unplugged
from the mains.
17
JBMA1400
