Idiomas disponibles
Idiomas disponibles
Installing with Base Using Lap/Shoulder Belts
8. Grab the Base at the Belt Path and pull
from side to side and front to back to
make sure it is installed correctly. The
Base should not move more than 2.5 cm
(1 in) in any direction.
If the Base moves too much, open the
SafeLock Belt Tensioner and remove a
little more slack from the vehicle belt,
then close and recheck. After this, if
the Base still moves too much, you
may need to try a different vehicle seat
location or installation method, or both.
9. Put vehicle belt in locked mode (see
vehicle owner's manual for more
information). In most vehicles, you can
switch Shoulder Belt Retractor into
locking mode by pulling out Shoulder
Belt all the way and then letting it rewind
into the retractor. Pull on the belt to make
sure it is locking.
Installing and Removing the Infant Car Seat
i
i
o o
37
