Aura AR35TK-IN Manual De Operación página 6

Operation
Sleep Operation
Press Pre button to enter sleep function
SLEEP
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts,temp.will become 1
higher than temp.setting.After another 1 hours,temp.rises
by 1 C futher.The unit will run for further 6 hours then stops
O
T
won't be too low for your sleep.
SLEEP operation starts
1 hr
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
2. In HEAT mode
1 hours after SLEEP mode starts,temp will become 2
lower than temp.setting.After another 1 hours,temp
decrease by 2 C futher.After more another 3 hours,temp.
O
C
rises by 1 futher.The unit will run for further 3 hours then
O
stops.Temp.is lower than temp. setting so that room
temperature won't be too high for your sleep.
Temp.setting
1 hr
Decreases 2
1 hr
Decreases 2
3 hrs
SLEEP
operation starts
In HEAT mode
3. In SMART mode
The unit operaters in corresponding sleep mode
adapted to the automatically selected operation mode.
3
SLEEP operation stops
Approx.6hrs
Rises 1 C
O
C
O
Unit stop
Unit stop
C
O
C
O
3 hrs
Rises 1 C
O
SLEEP
operation stops
4. In FAN mode
It has no SLEEP function.
5.Set the wind speed change when sleeping
If the wind speed is high or middle before setting for the
sleep, set for lowing the wind speed after sleeping.
If it is low wind, no change.
Note
When TIMER function is set, the sleeping function can't be
set up .After the sleeping function is set up
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of timing-on.
TURBO/QUIET Operation
When you need rapid heating or cooling, you can use TURBO function.
When silence is needed for rest or reading,you can use QUIET function
Press
TURBO/QUIET
C
O
and then achieve to the TURBO function. Press again this
button, th button, the remote controller will show
TURBO/QUIET
and then achieve to the QUIET function. Press again this
button , the QUIET function will be cancelled.
TURBO/QUIET
Note
During TURBO operation, in rapid HEAT or COOL mode ,
the room will show inhomogeneous temperature distribution.
Long period QUIET operation will cause effect of not too
cool or not too warm.
HEALTH Operation
(This function is unavailable on some models.)
C
O
Press Pre s s
EXT RA
F UNCTION
cycle di cycle display to
enter to health function.
The anion generator
a lot of anion effectively balance the quantity of position
and anion in the air and a
up the dust sediment in the room and finally clean the
air in the room.
button, the remote controller will show
button to enter additional options, when
, will flash. And then press
in the airconditioner can generate
lso to kill bacteria and speed
●
,
if user resets
,
CONFIRM
CANCEL