Safety Procedures And Notes Before Switching The Machine On - Skyfood AME-25-1 Manual De Instrucciones

4.1.3 Advices
In case of power shortage, immediately turn the machine OFF.
Use recommended or equivalent lubricants, oils or greases.
Avoid mechanical shocks as they may cause failures or malfunction.
Avoid penetration of water, dirt or dust into mechanical or electrical components of the
machine.
DO NOT modify original characteristics of the machine.
DO NOT remove, tear off or maculate any labels stuck on the machine. If any label has
been removed or is no longer legible, contact your nearest dealer for replacement.
READ CAREFULLY AND WITH ATTENTION THE SAFETY OR OPERATION
INSTRUCTIONS LABELS DISPLAYED ON THE MACHINE, AS WELL AS THE
INSTRUCTION MANUAL AND THE TECHNICAL CHARACTERISTICS WRITTEN
INSIDE.
4.2 Safety Procedures and Notes Before Switching Machine ON
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to be familiar with the instructions and that you have well understood all
information contained in this manual. If you have any question contact your
supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation could cause
electrical shocks as well as electrical leak. Before use, check conditions of all wires and
cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood. Every
function and operational procedure has to be very clear to the operator. Contact your
nearest Dealer for further questions.
Any manual command (switch, button or lever) shall be given only after being sure it is the
correct one.
IMPORTANT
07
Tabla - 02
Problemas
Olor de quemado y/o humo. Problema en el motor o
otras partes eléctricas.
La maquina liga, pero tarda
a girar la olla completa Correas mal ajustadas.
Nº04 (Figura 01).
Ruidos anormales. Rodamientos con defectos.
Caída de energia eléctrica.
L a m a q u i n a s e
Malo contacto en la
despriende durante la
llave liga/desliga.
operación.
Correas mal ajustadas.
Causas Soluciones
Llame a su revendedor.
Llame a su revendedor.
Llame a su revendedor.
Averigue si el enchufe está
conectado a la red eléctrica
y/o si hay energia eléctrica.
Llame a su revendedor.
Llame a su revendedor.
20