Koenic KDW 60111 A2 FS Manual De Instrucciones página 22

English
Warning
• Only use salt specifically designed for
use in dishwashers! All other types of
salt not specifically designed for use in
a dishwasher, especially table salt, will
damage the water softener. In case of
damages caused by the use of unsuitable
salt the manufacturer does not give any
warranty nor is he liable for any caused
damages.
• If there are spills of the salt, a soak or a
rapid program should be run to remove
the excess salt.
• Only fill with salt just before starting
one of the complete washing programs.
This will prevent any grains of salt or
salty water, which may have been split,
remaining at the bottom of the machine
for any period of time, which may cause
corrosion.
• The salt container must only be refilled
when the salt warning light in the control
panel comes on.
22
IM_KDW 60111 A2 FS_170802_V08_HR.indb 22
Adjusting salt consumption
Activate the setup mode: Close the
Fig.
6
door within 60 seconds after power
ON, press Start/Pause button and hold
for 5 seconds, the machine will enter
setting mode which is indicated by the
alternatingly blinking indicator lights of
and .
Adjust level of salt consumption:
Press the Start/Pause button to
select the proper setting according to
your local environment. Follow table
below to find correct setting.
Water Hardness level
°dH mmol/l
1)
0-5 0-0.94
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.0
35-55 6.1-9.8
The product will exit the setup mode
automatically 5 seconds after last
setting/operation of switch.
Note:
German degree of measurement for the
1)
water hardness
Millimol, international unit for water hardness
2)
Factory setting
*)
Contact your local water board for
information on the hardness of your water
supply.
Setting
2)
H1
H2
H3*
H4
H5
H6
2/8/17 12:02 pm