Idiomas disponibles
Idiomas disponibles
1.
List of parts:
NOTE!: The device requires 3 AAA batteries (1.5V) for correct operation. Batteries are not included.
2.
User manual:
Battery installation manual
The batteries should be installed by an adult. In order to place the batteries inside the
compartment, remove the screw using a Philips screwdriver and lift the flap. Next, place the
batteries inside the sound device (B) and secure the compartment by tightening the screw. The
figure 1 presents battery installation.
Safe use of batteries
•
Do not use different types of batteries together or mix old batteries with new ones.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries at the same time.
•
Non-rechargeable batteries are not to be recharged.
•
Rechargeable batteries are only to be charged under adult supervision.
•
Rechargeable batteries are to be removed from the toy before being charged.
•
Batteries are to be inserted with the correct polarity.
•
Insert batteries as shown in the picture.
•
Exhausted batteries are to be removed from the toy.
•
Remove batteries if the toy is not to be played with.
•
Do not dispose of discharged batteries into fire.
•
Before inserting batteries turn the toy off.
•
The supply terminals are not to be short-circuited.
•
Keep batteries out of reach of children.
•
Keep away from water.
•
Only adults should install, remove or change batteries.
•
Do not disassemble parts of the toy.
•
Do not short-circuit the power terminals.
Starting the sound element
The figure 2 presents the use of the noise generator.
The noise generator mechanism is operated with just one button.
Pressing the generator button briefly switches the noise on.
If the device does not detect sounds such as child crying/yelling, noise or loud sounds for 40
minutes, it enters the standby and cry detection mode for 3 hours:
-> If no aforementioned sounds are detected for 3 hours, the generator switches automatically off.
-> If said sounds are detected within the 3-hour period, the device activates for 20 minutes.
Afterwards, the device switches off and enters the standby and cry detection mode.
The cycle repeats until the device switches off.
The device may also be switched off manually, by pressing the module button briefly.
Volume level adjustments
When the device is switched on, press and hold the button for at least 2 seconds (this
causes the volume increase mode to activate), and (still) hold the pressed button to increase
the volume (in 7 levels). Releasing the button keeps the device at the given volume level.
If the button is pressed and held again for at least 2 seconds, the button will lower
the volume.
The mechanism stores the last volume level set before entering the standby mode in its
memory.
The device signals batteries running out of power with a sound signal.
Brief "beeps" during noise transmission indicate that the batteries are nearly discharged and
the device will soon shut down.
no.
A
B
Noise generator (sound device)
element
Plush toy
9
