TECshow NAVIGATOR 24 XL Manual De Usuario página 10

Playback
This controller uses the Channel Faders and Channel
Flash buttons for multiple uses. In this occurrence, Chan-
nel Faders 13-24 (37-48) are used for the playing back of
Scenes already recorded. This is only when the controller
is in the Chase-Scene mode. In this instance, Master Fad-
er A will control the manual fader controls, while Master
Fader B will control the Scenes being played back. Play-
ing a Scene can contain up to 1,000 steps. The term steps
and scenes are used interchangeably in this manual.
1. Tap the Mode Select button to select Chase-
Scene mode.
2. Tap the Page button to select the correct page
the program you wish to run is located.
3. Push master Slider B to its maximum position
(fully down).
4. Move the desired Channel Slider (13-24) to its
maximum, and the Scene will fade in depending
upon current fade time.
5. Move the channel slider to adjust the output
of the current program.
Observations
- The current mode is indicated by the 3LEDS.
Red is the Chase-Scene. Yellow is 2-scene preset
A/B. And Green is 1-24 single mode.
- You may press and hold down the relevant
Flash button for the Scene to trigger the button
momentarily.
Playing a Scene with Audio Triggering
1. Select your scene as described in the above
section.
2. Tap the Audio button until Led lights, indica-
ting AUDIO mode is active.
3. Use the Audio level slider to adjust the sensi-
tivity.
P. 10
NAVIGATOR 24XL
ENGLISH VERSION
4. To return to normal mode, tap the Audio but-
ton a second time, causing its LED to go out. AU-
DIO mode is disengaged.
Observations
- This is the process of using the built-in micro-
phone, or using the audio jack located on the
rear of the controller to use an alternative audio
source for triggering of the Scenes.
Playing a Scene with the Speed Slider
1. Select your Scene as described in the above
sections.
2. Move the Speed slider to SHOW MODE posi-
tion (fully down)
3. Press and hold the Rec Speed button & tap the
corresponding Flash button (13-24). The scene
tapped will no longer run with the standard beat.
4. Now you may move the Speed slider to select
your desired speed.
Observations
-
Be sure AUDIO mode is disengaged.Step #3 is
not necessary if the selected Scene is not recorded
with the Standard Beat.
Playing a Scene with the Standard Beat
1. Tap the Mode select button to select Chase-
Scene Mode.
2. Tap the Park button to select Mix Chase mode.
The LED lights, indicating the selection.
3. Select your Scene as described in the previous
sections.
4. Move the Speed slider until the display reads
your desired value.