Idiomas disponibles
Idiomas disponibles
Table of Contents
Table of Contents....................................................... 2
Safety Information...................................................... 2
Warranty...................................................................... 2
Pre-Installation........................................................... 3
Planning Installation................................................ 3
Tools Required......................................................... 3
Package Contents................................................... 4
Safety Information
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE NATIONAL ELECTRICAL CODE AND
LOCAL BUILDING CODES BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
PRECAUTIONS
Please read and understand this entire manual before
attempting to assemble, install, or operate this light fixture.
This light fixture requires a 120-277 Volt AC
power source.
Some codes require installation by a qualified electrician.
This light fixture must be properly grounded.
Make sure connections are secure
using wire nuts, crimp-on lugs or other
approved connecting devices
This light fixture should be installed outdoors
to a wall, eave or ground mount applIcation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Warranty
This is a limited warranty offered by the manufacturer for a period of five years from the date of purchase to its customers.
The manufacturer warrants to customers that the products will be free from defects in material and workmanship. The
obligation of the manufacturer under this warranty is limited to the provision of replacement of products and is extended to
the original purchaser of the product on presenting valid purchase receipt or other proof of date of original purchase
acceptable to the manufacturer. The receipt is required for rendering the warranty performance. Any warranty claims
without original proof of purchase would not be accepted.
It should be noted that the warranty does not apply to the manufacturer products that have been altered or repaired by
unauthorized personnel, have been subjected to neglect, abuse, misuse or accident or damages caused during shipping.
Any other products not manufactured by the manufacturer which have been supplied, installed and/or used in conjunction
with the manufacturer products are not covered under this warranty. Any damages caused by replacements bulbs, LEDs
or corrosion or discoloration of brass components are also not covered by this warranty.
Hardware Included................................................ 4
Installation................................................................ 5
Operation.....................................................................8
Care & Cleaning...........................................................9
Troubleshooting...........................................................9
3
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
WARNING: Risk of fire. Keep the fixture heads at
least 3 in. (76mm) from combustible materials.
CAUTION: Burn hazard. Allow the light fixture to cool
before touching.
NOTICE: If using dimming function, only connect to
0-10V approved dimming switches or control system
NOTICE: FCC Regulations state that any unauthorized
changes or modifications to this equipment not expressly
approved by the manufacturer could void the user's
authorization to operate this equipment.
INFORMATION: The device is tested and found to
comply with Part 15 of the FCC Rules. Operation is subject
to two conditions: (1) This device may not cause harmful
interference and, (2) this device must accept any
interference received, including any interference that may
cause undesired operation. These limits are designed to
provide reasonable protections against harmful interference
when the equipment is operated in a commercial environment.
2
Please contact 1-844-548-3776 for further assistance.
HOMEDEPOT.com
