Idiomas disponibles
Idiomas disponibles
Before starting any operation read this manual and keep it for further consultation.
The manufacturer declines any and every responsibility if the suggestions brought in this manual are not strictly
observed.
- Do not use the grill with wet hands, and wet/bare feet
- Place the grill at 3 cms minimum from walls or furniture, being sure that the same are not flammable
- Do not use electrical prolong wires without being sure of the load to bear in W.
- Do not pull the cable to disconnect the grill
- Do not leave the grill to atmospherically agents (sun, rain etc)
- Do not leave the grill within children range
- Do not plug in multiple sockets.
The installation operations must be carried out by qualified personnel and must be according to
the existing norms.
Once the appliance has been removed from packing, peel off the adhesive protection plastic film. The glue
residual must be removed accurately (do not use abrasive products).
Verify that the appliance is perfectly levelled on the base.
The appliance is set for a.c. operation at the power corresponding to the data brought on the technical
plate. The earth conductor cable is marked by green/yellow colours.
The appliance is supplied with a cable conform to the power stated on the technical plate, and it is only
necessary to connect a standard plug.
If direct connection is required, place between the appliance and the mains, a switch dimensioned to the
corresponding load in accordance with existing norms.
The earth green/yellow cable must not be discontinued.
Before connecting the appliance verify that:
A) The relief valve and the plant can stand the load of the appliance (see technical data plate)
B) The feeding plant is outfit with an efficient earth socket according to existing standards
C) The socket or the switch used for the connection are easily reachable with the appliance installed
The manufacturer declines every responsibility if the above accident preventions are not
respected.
A) To switch on the contact grill
Turn the main switch (Fig.1-A) to Pos. 1 and the temperature thermostat (Fig.1-C) to the desired
temperature.
B) Before using the grill
The grease residuals could produce smoke and unpleasant smells. It is therefore advisable to heat up the
plate for about 15 min. at the temperature of 300°C before using the same for the first time.
The appliance has two pilot lamps:
- green lamp: power on (Fig.1-B)
- yellow lamp: heaters on (Fig.1-D)
- to switch off the appliance set the main switch (Fig.1-A) back to Pos. 0
Before cleaning and maintenance operations, the appliance must be disconnected and cold.
The stainless steel parts must be treated with non abrasive detergents.
The control panel and the knobs should be wiped with a soft humid cloth.
The cast iron cooking surfaces have to be cleaned exclusively through the stainless steel spatula
supplied with the machine and/or by a dry abrasive sponge
Never wash the appliance with a jet of water as it might cause infiltrations in the electrical
components.
The control of the electrical components should be carried out by qualified personnel.
GB
WARNINGS
1) INSTRUCTIONS OF INSTALLATION
2) INSTRUCTIONS FOR USE
3) CLEANING AND MAINTENANCE
