Courtyard Creations TGS40SA Instrucciones De Armado

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS40SA-CS05-1
2
TGS40SA-CS04-1
3
62TGS40SAY101
4
17C17A0403001Y4
You will need the following tools:
-Phillips Screwdriver (Not included)
-Hex. Key Wrench (See Part #8)
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic holders
on the underside of the table top (#1) rim. Fasten
them together by using screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
!
assembled.
Do not sit or stand on this table.
!
A weighted umbrella base must be used when using an umbrella with this table.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and
!
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
V-4
INTENDED FOR RESIDENTIAL USE ONLY.
TGS40SA
PART Q'TY
TABLE TOP
LEG
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DO NOT RETURN TO THE STORE!
STOP
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
5
1 17C01A0708002Y4
4 6
17FA05040301-Y4
7
1
18000337002
8
4
17KAA0201----Y4
FIGURE 1
2
1
PART
BOLT M6*20
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX. KEY WRENCH 6MM
2
2
2
COURTYARD CREATIONS INC.
Q'TY
8
8
8
1
4