Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: Do not at any time make any
adjustment
to
the
unit without
first
stopping
engine
and
disconnecting
spark plug wire.
NOZZLEHEIGHTADJUSTMENT
The nozzle can be adjusted to any of five positions,
ranging from 5/8" to 4 1/8" ground clearance. The
nozzle height has to be adjusted according to the
conditions. Move the height adjustment levers
forward or backward to adjust the nozzle upward or
downward. It may be necessary to apply slight
pressure to lower handle assembly, when shifting
adjustment levers. See Figure 11.
NOTE: In general, raise the nozzle height to vacuum
a thick layer of leaves or to operate with the blower
chute. Lower the nozzle height for smoother surfaces.
ght
Adjustment
Lever
Figure 11
CARBURETOR A DJUSTMENT
WARNING:
If any
adjustments
(e.g.
carburetor)
are made to the engine
while the engine is running, keep clear
of all moving parts. Be careful of heated
surfaces and muffler.
The carburetor has been pre-set at the factory and
should not require adjustment. If your engine does
not operate properly due to suspected carburetor
problems, take your Yard Vacuum to a Sears Service
Center for repair and adjustment.
ENGINESPEED
The engine speed on your Yard Vacuum has been
set at the factory. Do not attempt to increase the
engine RPM. If you think that the engine is running
too fast or too slow, take your Yard Vacuum to the
12
nearest Sears Service Center for repair and adjust-
ment.
WARNING: Do not attempt to alter the
engine speed by tampering
with the
engine's
governor
linkage.
Doing so
could result in serious personal injury
and damage to the engine. The engine
RPM has been set at the factory.
REMOVING THE FLAILSCREEN
If the discharge area becomes clogged, remove the
flail screen and clean area as follows:
Stop the engine. Make certain the chipper
shredder vacuum has come to a complete stop.
Disconnect
and ground the spark plug wire
before unclogging the discharge chute.
Remove the vacuum bag or blower chute from
the unit as instructed in the OPERATION section
to obtain access to flail screen. See Figure 12.
Screw & Flat Washer
Lock Nu/t
Flail
REAR VIEW
Figure 12
Remove hex screw on right side of unitthat
attaches to the flail screen. See Figure 13.
Remove
Hex Screw
Figure 13
Remove hex screw and flat washer on top of rear
housing near mounting bracket and the lock nut
that secures flail screen. See Figure 12.
Remove and clean the screen by scraping or
washing with water. Reinstall the screen.
Tabla de contenido
