Idiomas disponibles
Idiomas disponibles
INSTALLING THE LIGHT KIT AND GLASS SHADE
(IF NOT USING THE DECORATIVE COVER)
CAUTION: To reduce the risk of electric shock, disconnect the electrical supply
circuit to the fan before installing the light kit and glass shade.
Step 1. Loosen two of the mounting plate screws on the mounting plate, and remove and save
the third mounting plate screw. (Fig. 20)
Step 2. While holding the light kit under your ceiling fan, push the square wire connectors
together. One from the fan and one from the light kit. (Fig. 20)
NOTE: The connectors will ONLY engage when the shapes of the connectors are matched.
(aligned)
Wire Connectors
Step 3. Tuck the connections neatly into the mounting plate. Place the key holes in the light
LED Light Kit
kit over the 2 mounting plate screws that were loosened from the mounting plate, and turn
the light kit (clockwise) until it locks in place against the mounting plate screws at the narrow
Mounting Plate Screw
sections of the key holes.
Replace the third mounting plate screw that was previously removed, and tighten all 3
Glass Shade
mounting plate screws to secure. (Fig. 20)
Fig. 20
Step 4. Raise the glass shade up to the fan, seat against the mounting plate, and turn
clockwise into the mounting plate until snug, DO NOT OVER TIGHTEN. (Fig. 20)
54" Ample | 19
