Idiomas disponibles
Idiomas disponibles
Ermenrich Reel SLR640 Laser Tape Measure
EN
Please carefully read the safety instructions and the user manual before using this product, otherwise it may result in hazardous
laser radiation and electric shock. Use the device only as specified in the user manual. Keep away from children.
The kit includes: laser tape measure, microUSB cable, strap, user manual, and warranty.
Getting started
Press and hold (8) for 3 seconds to turn the device on and off.
Units of measurement options
1
2
3
Display information
Single distance measurement mode
Distance
0.000m
0.00ft
0.0in
Area measurement mode
Single-distance measurement
When the device is turned on, it goes into single distance measurement mode automatically. Press (8) to turn
the laser on. Aim the laser beam at the target and press (8). The value will be displayed on the screen. Press
(8) to exit.
Continuous measurement
Press (8) to turn the laser on. Aim the laser beam at the target, press (8) and hold it for 1s. MAX, MIN, and the
last measured values will be displayed on the screen. Press (8) to exit.
Area measurement
Press (7) to enter area measurement mode. Aim the laser beam at the target and press (8) to measure two
sides of the target. The area will be calculated automatically.
Volume measurement
Press (7) to enter volume measurement mode. Aim the laser at the target and press (8) to measure the length,
width, and height of the three-dimensional target. The volume will be calculated automatically.
Reference point
The default reference point is the bottom end of the device. Press (7) and (8)
buttons simultaneously to change the measurement point from the bottom to
the top of the device.
Units of measurement
Press (7) and hold it for 1s to change the unit of measurement.
Area
0.000m
0.00ft
0.0in
3
2
2
2
Volume measurement mode
Volume
0.000m
3
0.00ft
3
0.0in
3
