Idiomas disponibles
Idiomas disponibles
•
Use recommended accessories
(refer to page 21).
Use of improper accessories
may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
•
Turn machine off if it jams. Blade or bit jams when it
digs too deeply into workpiece. (Motor force keeps it
stuck in the work.)
•
Always keep drive, cutterhead and blade guards in
place and in proper operating condition.
•
Feed work into blade or cutter against direction of
rotation.
CAUTION:
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool until it is
completely assembled according to the instructions.
REMOVE
CAPS
The planer/molder is shipped with caps on the threaded
shafts to avoid damage to shafts during shipping and
handling.
•
Unscrew and remove caps before turning the tool on.
•
Save caps for future use.
INSTALL
HANDWHEEL
ASSEMBLY
•
Slide handwheel onto crank lead screw so that the
spring pin on the crank lead screw is positioned
between the groove in the handwheel.
Handle Assembly............._
OapQ
Refer to Figure 1.
Check for shipping damage. If damage has occurred, a
claim must be filed with carrier. Check for complete-
ness. Immediately report missing parts to dealer.
The planer/molder comes assembled as one unit.
Additional parts which need to be fastened to planer
should be located and accounted for before assembling
or operating planer/molder.
A.
Handwheel Assembly
B. Bit Setting Gauge
C. Blade Height Gauge
D. T-wrench
E. Brass Punch
E
Open End Wrench
G. Allen Wrench
F
__A
G
E
" _
%_
/
[3
Figure 1 - Unpacking
Reset
Figure 2 - Assembly
Lifting Bars
MOUNT
PLANER TO WORK SURFACE
Refer to Figures 2 and 3.
•
Planer is designed to be portable so it can be moved
to job site, but should be mountable to stable, level
bench or table. See Recommended Accessories,
page 21.
MOUNTING INSTRUCTIONS FOR
OPTIONAL
TOOL STAND 222240
The Craftsman Planer/Molder Model 217330 can be
mounted directly on to Craftsman Multi-purpose
Tool
Stand Model 222240. To mount Planer/Molder to stand:
•
Place the Planer/Molder on stand top.
CAUTION:
Planer/Molder weighs approximately
140
Ibs. Two people may be required to lift Planer/Molder.
Use lifting bars (see Figure 2).
•
Position the Planer/Molder on stand top as shown in
Figure 3. Make sure that the four threaded holes on
the Planer/Molder base casting are aligned with four
slots as shown in Figure 3, page 4.
Refer to Figure 2.
The planer/molder
is shipped assembled except for the
handwheel assembly.
