Idiomas disponibles
Idiomas disponibles
EN
INSTRUCTIONS MANUAL
Ref. RE PLA DA1
1-CHANNEL DALI DIMMER
TECHNICAL FEATURESS
Supply voltage
Power consumption
Suitable type of
lighting fixture
Maximum number
of equipments
DALI signal
Outputs
Dimming range
Control
Maximum number
of pushbuttons
Dimensions
Weight
Working temperature
Storage temperature
Environmental
protection
Connection terminals
According to
the Standard
DESCRIPTION
● Dimmer switch for Fluorescence or LED lighting fixtures with DALI
Ballast or Driver.
● Unidirectional and Broadcasting communication. Individual
addressing is not allowed.
● Flush mounting into junction box.
● Built-in dimming speed selector knob.
● Controlled by one pushbutton or several connected in parallel:
· Brief press: switch on/off.
· Sustained press: dimming up/down.
● Optional Memory function.
OPERATION
● The control will performed by of one or more pushbuttons connected
in parallel:
· Brief press: switch the lamps on and off.
· Sustained press: dimming up or down. The dimming will be made
by a long press of the pushbutton, prolonging the pulsation until
the light reaches the desired level. At this moment release the
button so that the lamps keep the level reached. If during the
dimming we release the pushbutton and make a long push again
the direction of dimming will change.
● The Memory function allows two different ways to turn the lamps on:
· Mem: Each time the button is pressed to switch the lamps on,
they will be switched on at the level they were in before being
turned off.
· No Mem: Each time the button is pressed to turn the lamps on,
they will be switched on at the maximum level.
● The potentiometer built into the rear allows setting the desired
dimming speed.
INSTALLATION
Work with electrical equipment on the 230V mains
must be carried out only by qualified technicians!.
Switch off the mains before installing, removing or
handling of electrical equipment!.
NOTE: Do not forget to install the earth cable (
driver.
The connection of the external wired pushbutton is optional. It
depends if the installation requires wired pushbutton control or onle
with a wireless transmitter.
Install the dimmer according to the following steps:
1 - Switch the power supply off.
2 - Install the dimmer according to the wiring diagram.
Pushbutton
L
230V~ 50/60Hz
N
3 - Switch the power supply on.
4 - Set the desired dimming speed.
DINUY, S.A. Auzolan, 2, 20303, IRUN, SPAIN
WARNING: Hazardous voltage!.
L
www.dinuy.com
230V~ 50/60Hz
DALI Ballasts or Drivers
16V Synchronized
1 channel / 1 group
0, 10% ~ 100%
Pushbutton
Unlimited (without glow lamp)
46 x 46 x 24mm
0ºC ~ +40ºC
-30ºC ~ +70ºC
IP20 (EN60529)
"Lift" type.
Up to 6mm2 wire
EN 60669-2-1
KNX RF 1.R
RE PLA DA1
230V~ 50Hz
DA-
DA+
P
N
< 3W
64
35g
) of the ballast or
L
N
DA+
DA-
L
N
DA+
DA-
DALI
Ballast or
Driver
DALI
Ballas or
Driver
