Idiomas disponibles
Idiomas disponibles
MUFFLER
Do not operate tiller without muffler. Do
not tamper with exhaust system. Dam-
aged mufflers or spark arresters could
create a fire hazard. Inspect periodically
and replace if necessary. If your engine is
equipped with a spark arrester screen as-
sembly, remove every 50 hours for clean-
ing and inspection. Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of
each tilling season or after every 50 hours
of use, whichever comes first. Spark plug
type and gap setting are shown in "PROD-
UCT SPECIFICATIONS"
on page 4 of this
manual.
TRANSMISSION
Your transmission
is sealed and will not
require lubrication unless serviced.
CLEANING
Do not clean your tiller when the engine
and transmission
are hot. We do not rec-
ommend using pressurized water (garden
hose, etc.) to clean your unit unless the
gasket area around the transmission
and
the engine muffler, air filter and carburetor
are covered to keep water out. Water in
engine will shorten the useful life of your
tiller.
• Clean engine, wheels, finish, etc. of all
foreign matter.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with auto-
motive type wax.
A%CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come into contact with plug.
TILLER
TO ADJUST
HANDLE
HEIGHT
Factory assembly has provided lowest
handle height. Select handle height best
suited for your tilling conditions.
Handle
height will be different when tiller digs into
soil.
1. If a higher handle height is desired,
loosen the four nuts securing handle
panel to engine brackets.
2. Slide handle panel to desired location.
3. Tighten the four nuts securely.
Engine Brackets
_
_-_Handle
Panel
i_/
:=_-NUtl_(e_'Ss_d2e
0
,g_-_/il
'_ of Tiller
TINE ARRANGEMENT
Your outer tines can be assembled in
several different ways to suit your tilling or
_ltivating
needs.
CAUTION: Tines are sharp. Wear
gloves or other protection when handling
tines.
NORMAL TILLING - 26" PATH
• Assemble holes "A" in tine hubs to holes
"B" in tine shaft.
_-_
Clevis Pin
Outer Tine
Hairpin Clip
Inner Tine
MID-WIDTH
TILLING - 24" PATH
• Assemble holes "A" in tine hubs to holes
"C" in tine shaft.
A
NARROW
TILLING/CULTIVATING
-
12-3/4"
PATH
• Remove
outer tines.
Ioo oo]
Inner Tines Only
13
