Qilive Q.7692 Manual De Instrucciones página 9

Chorro dental de agua
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
4. BEFORE FIRST USE
1.
Unpack the product and all parts.
2.
Make sure the product is not damaged and that there are no missing accessories.
Contact our after-sales service if there are any missing or damaged parts.
3.
Clean the product and all accessories (→ "6. CLEANING AND CARE").
NOTE:
There may be moisture inside your new unit (water tank and suction tube) left from the
distilled water used on manufacturing for product testing.
5. OPERATION
Charging the Oral Irrigator
Before the first use and when the battery is low, fully
charge the battery for approximately 16 hours.
1. Plug the adapter of the charging base into a suitable
wall socket.
2. Ensure the main unit is turned off.
3. Place the main unit upright on the charging base to
start charging (Fig. 1). The
while the unit is charging, and will stay on when it is
fully charged.
Using the Oral Irrigator
1.
Remove the main unit from the charging base.
Insert the jet tip firmly onto the main unit (Fig. 2).
2.
3.
Fill the water tank with tap water (not exceeding 40 °C) using one of the following
methods:
Open the water tank side cap to fill the tank, then close the cap firmly (Fig. 3).
Or, remove the water tank from the main unit by sliding it down, fill the water tank,
and then reattach it to the main unit (Fig. 4).
IMPORTANT: Do not fill mouthwash in the water tank. Certain types of mouthwash may
cause the water tank or housing to crack and damage the unit.
4.
Press the
button to select your preferred mode. The mode can be switched
during irrigation by pressing the button again (Fig. 5).
Normal Mode: For normal cleaning.
Soft Mode: For gentle cleaning on sensitive gums.
Pulse Mode: For cleaning and gum massaging.
5.
Lean over a washbasin, hold the oral irrigator upright and gently place the jet tip in
your mouth pointing toward your teeth. Keep your mouth slightly open to allow the
irrigation water to flow out.
indicator light will blink
9
EN
loading