Maytag MAH-1 Guía De Uso Y Cuidado página 11

II!IEFORE YOU
CALL
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care procedures, see the
enclosed LaunderingTips booklet.
• Use Max Extract option.
Load is Too Wet at • Try using a high efficiency detergent to reduce sudsing.
End of Cycle • Load is too small.Very small loads (one or two items) may become unbalanced and not spin
out completely.
• Make sure door is firmly closed.
• Make sure hose connections are tight.
Leaks Water • Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid overloading.
• Use high efficiency detergent to prevent over-sudsing.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.
Won't Spin • Close the door and push the start/pause pad. For your safer7, washer will not tumble or
or Drain spin unless the door is closed.
• After pressing the start/pause pad, it will take 30 seconds before the clothes washer begins
to spin.The door must lock before spin can be achieved.
• See "Tub is Completely Full of Suds" below.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close door and push the start/pause pad to start the clothes washer. For your safer7,wash-
Stops er will not tumble or spin unless door is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• Check screens on inlet hoses at the faucets for obstructions. Clean screens periodically.
• Run the clothes washer through another complete cycle using cold water.
Tub is Completely
Full of Suds • Reduce detergent amount for that specific load size, soil level and water hardness.
• Use high efficiency or low sudsing detergent specially formulated for front load washers.
• Turn both faucets on fully.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucets. Flush water lines.
• Check the water heater. It should be set to deliver a minimum of 120°F (49°C) hot water at
the tap. Also check water heater capacit7 and recovery rate.
Fills with the • Disconnect hoses and clean screens. Hose filter screens may be plugged.
Wrong • When warm rinse is selected, only the final rinse will be warm. The first two
Temperature rinses will be cold.
Water • As the washer is filling, the water temperature may change as the automatic temperature
control feature checks incoming water temperature. This is normal.
• While the washer is filling, you may notice just hot and/or just cold water going through the
dispenser when cold or warm wash temperatures are selected. This is a normal function of
the automatic temperature control feature as the washer determines the temperature of the
water.
I 0 CONT.