Westinghouse SR74FA02C-08 Instrucciones

FOR FIRST TIME USE: SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8 -12 HOURS WITH THE SWITCH IN
THE "ON" POSITION TO FULLY CHARGE THE BATTERY.
The intelligent solar LED motion activated light measures the available battery power capacity and adjusts the light's performance to
maximize runtime.
Tools Required
Pencil
Phillips-head
Screwdriver
1
Marking the location
Mark the location where you want to mount the light fixture (Part C) .
Measure the width of two holes on the back of the mounting plate
(Part D) and mark holes for the 2 screws (Part A) on the surface.
The distance between the two holes is 2.36in. (60mm).
Drill two holes.
2
Mounting the light xture
wall anchors Part
Insert the (
Secure the mounting plate (Part D) in place with the screws (Part A).
Mount the light on the mounting plate (Part D) by aligning the holes
on the back of the light to the knobs on the front of the mounting plate.
Align, insert, and slide down to lock in place.
NOTE:
Light fixture will stay on 30 seconds when triggered by motion and revert back to standby mode of 20 lumens until motion is detected.
For best performance, mount the light a minimun 6 feet (1.8 m) above the ground. Detection range is 26 feet (8 m), detection angle is 120°.
Light fixture uses radio frequency technology to link, and should not be greater than 98 feet (30 m) between the neighboring/adjacent lights.
When one light is triggered by motion both lights will activate. The package includes 2 lights. These 2 lights are factory linked, and can not be
linked with more of the same type light or any other lights.
TROUBLE SHOOTING
If light doesn't turn on, check the
battery to ensure that it is making
secure contact with the terminals.
If this doesn't work, replace with a
new battery.
Electric drill
drill bit size:
ø7.5mm (3/10 in.)
B) so they are flush with the surface.
Slide the power switch to the "OFF" position.
Use a Phillips head screwdriver to remove the
4 screws holding the battery cover in place.
Replace old battery with a new 3.7V, 2000 mAh
lithium (18650) rechargeable battery.
Replace the battery cover by aligning it properly
and replacing the 4 screws removed earlier.
Slide the power switch to the "ON" position.
For optimal performance, allow light xture to charge
in full sunlight for 8-12 hours, to fully charge the
battery.
SOLAR LED AREA WALL LIGHT WITH MOTION SENSOR
INSTRUCTIONS
INSTALLATION
Hardware Included
(A)
Screw X 4
Parts
A
B
REPLACING THE BATTERY
ITEM: SR74FA02C-08
(B)
Wall Anchor X 4
(C) (D)
Light Fixture X 2
2.36in. (60mm)
x x
D
C
Screws
Battery Cover
Power Switch
Mounting Plate X 2
Battery
E