Idiomas disponibles
Idiomas disponibles
To enter your product settings, press the "+" and "-" buttons on your screen for 5 seconds.
Warning ! If you change all the basic settings, you will change the performance and status of your product. You
are advised to change only the settings below :
Work on this product should only be carried out by a qualified professional.
Menu
P01
P02
P04
P09
To begin with, we recommend checking the light beams (cables) for each error.
ERROR
E06
E07
E08
E09
E10
E11
E30
Go to your product settings by holding down the "+" and "-" buttons. Go to setting P20 and enter the
Maintenance
Lubrification
The folding system of your scooter needs to be lubricated every 6 months with a neutral
non-corrosive oil.
When your brake performance begins to decline, you can adjust the
System settings
Setting the distance measurement unit
0 = No sleep mode
0 = Immediate start
Check that your battery is properly charged. If it is, check the state of the battery.
Check the condition of the motor(s).
Check that the throttle trigger is in good condition.
If the cables are in good condition, the problem could be linked to the motherboard.
This problem may be caused by the motherboard.
sensitivity of your brake cables.
Settings
Brightness adjustment
0 = KM
1=MILES
Screen saving time
1 to 60 = The number of minutes of standby time
Startup mode
1 = Impulse to start
Error codes
PROBLEM
Battery fault
Engine fault
Trigger fault
Motherboard fault
Replace the motherboard.
Electrical harness fault
Electrical harness fault
Communication fault
value 0.
28
Brake
