Idiomas disponibles
Idiomas disponibles
3. TRANSPORT, HANDLING AND INTERMEDIATE STORAGE
Lifting
Never lift the pump by means of its electric cable, but use the special handle.
The electric pumps have to be lifted observing the following recommendations, according to their weight
(indicated on their packing): Up to 20 kg: manually by one person; From 20 to 60 kg: manually by two persons;
More than 60 kg: by means of a suitable lifting device.
Storing and preservation
If the pump/electropump remains inactive at low temperatures (the water inside the pump could freeze and
cause serious damage) or, at any rate, for a period exceeding three months, it is a good idea to empty the
pump and protect it by applying suitable products to its surfaces.
To empty the liquid, see the chapter 8.
4. TECHNICAL SPECIFICATIONS AND USE
Identification of the product
The identification data and technical characteristics of the pump/electropump are shown on the plate attesting
to its conformity to CE standards (fig.1).
Description of the product
Submersible drainage electric pumps SDLV-TEX SDLV-TEXD.
Technical specifications
Pump type
Impeller
Motor
Standard electric feeding
Tension
Frequency
Electric cable type
Hydraulic seals
Bearings greasing
Temperature of the liquid
Permitted ambient conditions
Permitted maximum pressure
Performances
Frequency of the starts
Installed power (kW)
Start/ hour (2-pole motors)
Sounding pressure level
Use
Never use the electric pump in explosive atmospheres or to pump inflammable or dangerous liquids.
Never use the electric pump for liquids to be consumed in human feeding.
In order to avoid seriously damaging the components, observe the following recommendations:
-
never use the pump in absence of liquid;
-
never use the pump out of the water;
-
never use the pump with null delivery (closed delivery);
-
do not immerse the pump under 20 m;
-
always use the pump with a delivery indicated in the working diagram.
Characteristics of the liquids to be pumped
- PH between 6÷7.7
- Temperature max
40°C
- Dimension of solid bodies in suspension: SDLV-TEX 20 mm; SDLV-TEXD 4 mm;
The bodies in suspension shall not be excessively abrasive and they shall not be characterised by shapes
tending to agglomerate.
SDLV-TEX – SDLV-TEXD
Vortex
Asynchronous - single or three-phase
Protection degree
Insulation class
(220-240) / (380-415) / (600-720) V
50 Hz
H07RN-F
Mechanical
Standard permanent grease
°
max 40
Non explosive atmosphere
6 bar
3
Capacity up to 33m
/h – Head up to 14 m
Up to 22 kW
15
Installed power (kW)
0,75
1,1
1,5
- Density not higher than 1 kg/dm3 and viscosity equal to the water one
- Quantity of solid bodies in suspension max 1%
8
IP 68
F
Sounding pressure level (dBA)
61
61
63
