Idiomas disponibles
Idiomas disponibles
User Manual
EDID command
The following commands are used to set EDID mode for the inputs
Commands
SET IN EDIDMODE w
SET EDID-USER w
GET IN EDIDMODE
Troubleshooting
There is no image displayed on the screen.
Please check the max. resolution supported by the source and the screen and if the output resolution
is set to 4K and the 4K-AUTO setting is OFF.
Long press the AUTO button on the front panel to change the output resolution to the needed one and
set 4K-AUTO to ON.
There is no audio signal.
Since audio selection is separated from the video selection, please check if the audio selection comes
from the required source. By default is set on Win1.
Please check if Audio-Mute is enabled.
Please check if Audio Volume value is more than 0; if there is no feedback adjusting the volume it
should be because the audio source is a non-LPCM format such as AC3 or DTS 5.1. The volume can
be changed only with LPCM format.
Please check if the audio format selected is supported by the audio device connected.
There is no TCP/IP connection.
Please check the IP address, NetPort, Baud rate settings. The switch and the router connected must
be in the same network segment.
Details
w is one of the following:
4K60-2.0, 4K60-5.1, 4K60-7.1, 4K30-2.0,
4K30-5.1, 4K30-7.1, 1080p60-2.0,1080p60-5.1,
1080p60-7.1,1920x1200, 1680x1050, 1600x1200, 1440x900,
1360x768, 1280x1024, 1024x768, 720p, AUTO, USER
Default: 4K60-2.0
Return: IN EDIDMODE w
Switcher can only support 256 bytes EDID-USER data.
w is 256 bytes EDID data.
Return: EDID-USER OK
Return: IN EDIDMODE w
English
